Agri-Fab Smartlink Platform 45-04731 - Manual (Page 4)

4
Secure the ends of the hitch tubes together using two 7.
5/16 x 2-1/2" hex bolts (8) and 5/16" nylock nuts (14).
Do not tighten yet. See figure 3.
fIGure 2
fIGure 3
Attach the hitch tubes (5) to the third hole from the 6.
front of the tray assembly using two 5/16 x 1" hex
bolts (11) and 5/16" nylock nuts (14).
Do not tighten
yet. See figure 2.
8
8
14
11
11
14
14
5
5
assemBlY InsTruCTIons
assemBlY of smarTlInk PlaTform
Rotate the end plates attached to the tray assembly 1.
down to a vertical position as shown in figure 1.
Remove the bolt and nylock nut from the front right
2.
corner of the tray assembly. See figure 1.
Attach the lift handle catch (6) to the front holes of the
3.
tray assembly using the bolt and nylock nut removed
in step 1. See figure 1.
Assemble four 5/16 x 3/4" hex bolts (9) and 5/16"
4.
nylock nuts (14) to the four empty corners in the tray
assembly. See figure 1.
Tighten
5. all eight of the 5/16 x 3/4" hex bolts in the
corners of tray assembly.
Tools reQuIreD for assemBlY
(2) 3/4" Wrenches
(2) 1/2" Wrenches
fIGure 1
Pre-assemBleD BolT
6
9
14
Pre-assemBleD nuT
Attach the lift tube assembly (2), the lift handle (3), 8.
and the hitch tube (5) to the rear hole on the right
side of the tray using a 5/16 x 1-1/2" hex bolt (10) and
5/16" nylock nut (14).
Tighten the nut then loosen 1/2
turn. See figure 4.
Secure the top hole of the lift handle to the top hole
9.
of the lift tube assembly with a 5/16" x 1" hex bolt (11)
and 5/16" nylock nut (14).
Tighten. See figure 4.
fIGure 4
10
14
3
5
14
11
2