beautypg.com

Avocent 416 User Manual

Page 39

background image

Chapter 3: Basic Operations

33

Keyboard Hotkey Sequences

Key Sequence

Action

Kn

Sets the keyboard scan set where n is a scan set number 1-3.

MR

If you hot-plug your mouse cable, you may experience a loss of
mouse signal. Use this command to restore the signal if you are
using a PC with a standard PS/2 mouse driver.

MW

If you hot-plug your mouse cable, you may experience a loss of
mouse signal. Use this command to restore the signal if you are
using a PC with a Microsoft IntelliMouse or other wheel mouse driver.

AV

Displays the current fi rmware version of your AutoView 424.

SG

Enables the scan Go command (by address only).

SH

Enables the scan Halt command.

M+

Enables mouse suspension of scanning.

M-

Disables mouse suspension of scanning.

H1

Changes the hotkey sequence to the default: (NumLock,

-

).

H2

Changes the hotkey sequence to the 1st alternate: (NumLock, *).

H3

Changes the hotkey sequence to the 2nd alternate: (Ctrl, ~).

OSD0 Disables the OSD sequence.

OSD1 Changes the OSD sequence to the default: (Ctrl, Ctrl).

OSD2 Changes the OSD sequence to the 1st alternate: (Alt, Alt).

OSD3 Changes the OSD sequence to the 2nd alternate: (Shift, Shift).

ZM

Use this command to resynchronize the mouse after a
device or computer hot-plug. Repeat, if necessary, until
synchronization is re-established.

NOTE: Using the ZM command while the mouse is
operating correctly will cause the mouse to lose sync.

This manual is related to the following products: