Kolpin 4433 – Universal Mount Stereo Console - Manual

Please read and understand these instructions completely before installation to avoid injury to yourself or damage to the vehicle
or accessory.
Dealer: These instructions contain important information for future reference and must be given to the customer at time of purchase or
upon completion of installation.
Parts List:
Please Note: These particular instructions demonstrate mounting
the Universal Mount Stereo Console on a generic flat surface. Use
your best judgement in determining where to locate the mounting
hardware in order to provide a secure and stable installation.
1) Remove the four M6 x 35mm screws, lock washers and flat
washers from your Universal Mount Stereo Console as indicated
in Image “A”. Retain these for reassembly.
2) Separate the two halves of the console, making certain not to
damage or disconnect any wires. Carefully disconnect the USB
plug, red and white RCA jacks, DIN connector and speaker plug
as indicated in Image “B”. At this point, you should be able to
completely separate the two halves.
3) Position the upper half of the console on your desired mounting
location. Be certain to choose a flat surface that provides a
secure and stable installation. Using this as a template, mark the
four mounting points as indicated in Image “C”.
ITEM PART NAME DESCRIPTION QTY.
1 Stereo Console Universal mount stereo console (for use with 12v power source only) 1
2 Screw M6 x 60mm lg. button head cap screw, stainless steel 4
3 Washer 20mm bonded sealing washer, galvanized 4
4 Washer M6 x 25mm O.D. fender washer, stainless steel 4
5 Nut M6 nylock nut, stainless steel 4
6 Cable Tie Cable tie, black plastic 3
Universal Mount Stereo Console
Installation Instructions
Stock No.: 4433
1 2
3 4
Image A
USB Plug
Red RCA Jack
White RCA Jack DIN Connector Speaker Plug
View from Rear of
Black Box
Use Plug Marked
“FRONT”
Image B
Your Mounting Surface
2 1
3 4
Image C