Kolpin 3505 – UTV Dual Speaker User Manual
Utv dual speaker installation instructions, Warning, Stock no.: 3505

Please read and understand these instructions completely before installation to avoid injury to yourself or damage to the vehicle
or accessory.
Dealer: These instructions contain important information for future reference and must be given to the customer at time of purchase or
upon completion of installation.
Parts List:
Please Note: The UTV Dual Speaker was designed to fit most UTV roll cages. Because roll cages may vary in design, use your best
judgement in determining where to locate the speaker in order to provide a secure and stable installation.
1) Mount the two sets of brackets on the vehicle’s roll cage as indicated in Image “A1”. Insert the tongue of the male bracket into the
groove of the female bracket and close the two halves. Please note that the threaded inserts of the bracket should face the same
direction you intend to direct the speakers.
2) Secure the brackets with the supplied M6 x 35mm lg. T-handle knobs,
M6 x 12.5mm spacers, M6 x 25mm spacers and M6 nylock nuts as
indicated in Image “A2”. Do not tighten at this point. The brackets will
need to be adjusted before this is done.
3) While holding the speaker in your desired mounting location, slide the
brackets along your roll cage until the threaded inserts line up with the
mounting plates on the back of the speaker as indicated in Image “B”.
4) Once the brackets are aligned, finish tightening all of their hardware.
Do not overtighten the T-handles as this will cause them to break the
mounting brackets.
5) Finish mounting the speaker by attaching it the the mounting brackets
with the supplied M6 x 20mm lg. button head cap screws and M6 lock
washers as indicated in Image “C”.
6) Complete the installation by running and securing the speaker wires to
your stereo using the diagram indicated in Image “D”.
7) Maintenance and Care: Tighten all hardware after first use and
periodically thereafter.
Failure to follow these
installation instructions
completely may void any warrantable
components and result in property damage
or personal injury. NEVER operate or transport
UTV with unsecured cargo.
For additional assistance, please contact our
customer service department at:
Kolpin Outdoors, Inc.
205 N. Depot Street | Fox Lake, WI 53933
1.877.956.5746
UTV Dual Speaker Installation Instructions
Stock No.: 3505
ITEM
PART NAME
PART NO.
DESCRIPTION (60-3505)
QTY.
1
Speaker
100-3505
UTV dual speaker assembly
1
2
Bracket
52-0017
Male bracket half
2
3
Bracket
52-0018
Female bracket half
2
4
T-Handle Knob
52-0013
M6 x 35mm lg. T-handle knob, stainless steel
2
5
Spacer
57-0006
M6 x 12.5mm lg. spacer, aluminum
2
6
Spacer
57-0005
M6 x 25mm lg. spacer, aluminum
2
7
Nut
77-0006
M6 nylock nut, stainless steel
2
8
Screw
75-0003
M6 x 20mm lg. button head cap screw, stainless steel
4
9
Washer
76-0002
M6 lock washer, stainless steel
4
Roll Bar
M6 x 25mm
Spacer
M6 x 12.5mm
Spacer
M6 Nylock Nut
M6 x 35mm
T-Handle Knob
Image A2
Female Bracket
Male Bracket
Roll Bar
Image A1
M6 Lock Washer
M6 x 20mm Button
Head Cap Screw
Image C
Image B
WARNING
!
White Wire
Black Wire
+
–
Red Wire
Left
Right
Green Wire
+
–
Image D