Warning – Kolpin 3500 – Universal UTV Stereo with Dual Speaker User Manual

Page 2

Once the mounting plate is secure, slide the bracket along

your vehicle’s roll cage until the commander is in your

desired location as indicated in. Images “4.1” and “4.2”.

Be certain the commander is easily accessible, but does

not interfere with the driver’s visability.

d) Once you have reached your desired location, finish

tightening the bracket hardware. Do not overtighten the

T-handles as this will cause them to break the mounting

brackets.

e) Thread the commander’s wire harness through the large

hole of the mounting plate. Fasten the commander to the

mounting plate by peeling back the two rubber flaps on

both sides of the unit and using the supplied M3 x 25mm lg.

phillips flat-head style machine screws as indicated in

Image “5”.

2) Mounting the Tuner/Amplifier to your UTV

When choosing a mounting location for the tuner/amplifier, take

into consideration wire lengths, ventilation, and protection from

the elements. Please Note: It is necessary to follow the

manufacturer’s specific installation instructions when mounting

the tuner/amplifier. These are located with the stereo unit.

3) Mounting the Dual Speaker to your UTV

When choosing a mounting location for the Dual Speaker, take

into consideration wire lengths, ventilation, and protection from

the elements. Please refer to the installation instructions

located with the Dual Speaker before mounting.

Maintenance and Care: Tighten all hardware after first use and

periodically thereafter.

Failure to follow these installation instructions completely may void any warrantable components and result in

property damage or personal injury. NEVER operate or transport UTV with unsecured cargo.

For additional assistance, please contact our customer service department at:

WARNING

Top Mounting – Image 4.1

Side Mounting – Image 4.2

M3 x 25mm

Phillips Flat-Style

Machine Screw

Image 5