King Technology Prevail System - Manual (Page 9)

Replacing Cap O-Ring
1. Hold cap in front of you
upside down with the o-ring
groove facing up. Place one
end of o-ring into cap groove
at the point closest to you.
Hold o-ring down with the
thumb and index finger of one
hand.
2. Take hold of the far end of
the o-ring with the thumb and
index finger of the other hand.
Roll o-ring slightly back
towards you as you stretch the
o-ring into the remainder of the
cap groove.
3. Lubricate o-ring often with
silicone lubricant that came
with your Cycler. DO NOT
USE petroleum based
lubricants.
COPY
COPY
COPY
COPY
OTHER COPY?
SILICONE
LUBRICANT
• To replace, simply unscrew
and replace with the new one.
• Front of Cycler
Cycler Maintenance
• In the back of the Cycler
depress center of locking
pin with a finger and pull
pin out of dial.
• Turn control dial back
and forth as you pull it out
of the housing.
COPY
COPY
COPY
COPY
OTHER COPY?
SILICONE
LUBRICANT
• Replace both o-rings.
Apply silicone lubricant
that came with your Cycler
on o-rings.
• Carefully insert control
dial back into housing.
• Replace locking pin by
pushing it through the
slots on the dial until it
locks into place.
1.
2.
3.
4.
5.
9
Center of locking pin
Replacing a Knob
Replacing the Control Dial O-Rings
• Back of Cycler