INTELLINET NETWORK 524698 Wireless 150N USB Adapter User Manual User Manual
Page 12
p
roFile
C
onFiguration
Profile Name: Define easily recognizable profile names to identify the
different networks.
SSID: The SSID (up to 32 printable ASCII characters) is the unique name
identified in a WLAN. The ID prevents the unintentional merging of
two co-located WLANs. If you specify an SSID for the adapter, then
only the device with the same SSID can interconnect to the adapter.
To add a nearby network to the profile list, pull down the menu to view
all the networks that can be selected.
Power Save Mode: The two power-saving functions are available only
when Network Type (see below) is set to “Infrastructure.”
• CAM (Constantly Awake Mode): With this selected, the adapter
will remain in an active mode.
• PSM (Power Save Mode): Enable the adapter in the power-save
mode when it is idle.
Network Type: Select from the drop-down menu.
• Infrastructure: This operation mode requires the presence of an
802.11 access point. All communication is done via the AP or router.
• Ad-Hoc: Select this mode to connect to another wireless station in
the wireless LAN network without using an access point or router.
Tx Power: To lower the transmit power of the adapter to reduce the power
used by the system, select a lower percentage from the drop-down
menu.
NOTE: A lower power level will result in lower signal strength
and reduced coverage range.
CONFIGURATION
12