INTELLINET NETWORK 525206 Wireless 300N High-Gain USB Adapter User Manual - Manual (Page 14)

10
Parameter Description
Refresh – Refresh the adapter list in the “B“ block.
Mode – There are two modes: Station and Access Point. If
“Station“ is selected, the adapter works as a wireless adapter. If
“Access Point“ is selected, the adapter will works as a wireless
AP.
View – Enable “Status Bar“ and the “D“ block in the utility will
display the current status of the utility.
About – To check the version of the utility, select this item.
This is a list for you to configure several adapters in your PC from
the utility.
Show Tray Icon – To show the icon in the system tray, select the
item.
Disable Adapter – This is to disable or enable the adapter.
Windows Zero Config – To configure the adapter from Windows
XP Zero Configuration, check the item.
Radio Off – This is to turn off or turn on the radio of the adapter. If
the radio is turned off, the adapter will not work.
This is the status bar that displays the current status of the utility.
To close it, disable the “Status Bar“ in the “View“ item.
There are several tabs in the block for you to set up the functions
of the adapter. Refer to the descriptions in the following sections.
A
B
C
D
E