Hach-Lange DRB 200 Thermostat - Manual (Page 15)

15
Section 2 Instrument Use
2.1 Starting-up
DANGER
The ventilation
slits in the lid must
not be covered, or
overheating may
occur.
1. Place the instrument on a stable, level, heat-resistant
surface.
2. Plug in the power cord into a power socket (100–230 V
+5%/–15%, 50/60 Hz).
3. Switch on the instrument by switching the power
switch (Figure 4).
4. After initialization, the instrument will beep once,
indicating that it is ready for operation. The display
always shows the most recent setting of the
temperature programs after initialization.
Figure 4 Back View of the DRB 200 Digital Reactor Block
2.1.1 Setting the Language
The default factory setting is English. To change the
default setting:
1. Hold down the left key while switching on the
instrument.
Initializing
V X .X
1. Power Switch 2. Power Plug 3. Nameplate