Install multiple bottles, Plumb the sampler – Hach-Lange SD900 Refrigerated Sampler, SD900 AWRS Basic User Manual User Manual
Page 11
Install multiple bottles
When multiple bottles are installed, a distributor arm moves the sample tube over each bottle.
Sample collection automatically stops when the specified number of samples have been collected.
1. Clean the sample bottles. Refer to
on page 10.
2. Assemble the sample bottles as shown in
. For eight or more bottles, make sure that the
first bottle goes next to the bottle one indicator in the clockwise direction.
3. Put the bottle assembly in the sampler. For eight or more bottles, align the wires in the slots in the
bottom tray.
Figure 5 Multiple bottle installation
1 Retainer (1322)
4 8–24 bottle tray (1511)
7 Front of sampler
2 Retainer (1056)
5 Slot for bottle tray
8 Removable tray (AWRS)
(5697600)
3 Bottle one indicator
6 Floor of refrigerated sampler
9 Insert (refrigerated sampler)
(2038)
Plumb the sampler
Install the intake tube in the middle of the sample stream (not near the surface or bottom) to make
sure that a representative sample is collected.
1. Connect the tubing to the sampler as shown in
English 11