Hach-Lange DR 5000 User Manual User Manual
Dr 5000
Table of contents
Document Outline
- Table of Contents
- Section 1 Specifications
- Section 2 General Information
- Section 3 Installation
- Section 4 Start Up
- Section 5 Standard Operations
- 5.1 Overview
- 5.2 Instrument Setup mode
- 5.3 Store, recall, send and delete data
- 5.4 Stored Programs
- 5.4.1 Select a saved test/method; enter user-specific basic data
- 5.4.2 Stored program options
- 5.4.3 Use of program timers
- 5.4.4 Set the reading mode
- 5.4.5 Set the dilution factor
- 5.4.6 Run a standard adjust
- 5.4.7 Set the chemical form
- 5.4.8 Run a reagent blank
- 5.4.9 Analysis of samples
- 5.4.10 Update/edit tests
- 5.4.11 Add stored programs to the favorite programs list
- 5.5 Barcode Programs
- 5.5.1 Complete a barcode 13 mm test/vial
- 5.5.2 Select the measuring range
- 5.5.3 Select the chemical evaluation form
- 5.5.4 Basic test-specific and sample-specific data settings
- 5.5.5 Sample blank
- 5.5.6 Update/edit barcode tests
- 5.5.7 Upgrade of the instrument software
- 5.5.8 Program an own barcode-readable application with LCW 906
- Section 6 Advanced Operations
- 6.1 User Programs
- 6.2 Favorite Programs
- 6.3 Standard Addition - monitoring/checking results
- 6.4 Single Wavelength (absorbance, concentration and transmittance measurements)
- 6.5 Multi-Wavelength mode - measurements at more than one wavelength
- 6.6 Wavelength Scan mode - recording of absorbance and transmittance spectrums
- 6.7 Time course of absorbance/transmittance
- 6.8 System checks
- Section 7 Maintenance
- Section 8 Troubleshooting
- Section 9 Replacement Parts
- Section 10 Contact Information
- Section 11 Warranty, liability and complaints
- Index