Hach-Lange LZY367 cleaning set for filtration probe sc - Manual (Page 5)

3
Cleaning set LZY367
Cleaning the FILTRATION PROBE sc
1. Ensure all steps in section Installation of the cleaning set LZY367 on page 2 have
been performed.
2. Open the main menu on the analysis instrument.
3. Select the menu MAINTENANCE>TEST/MAINT>PREPUMPING>PREPUMPING
PROBE and trigger a pump cycle.
4. Wait until the pump cycle is complete.
Note: Ensure the tubes are not drained!
5. Hang the ends of the tubes on the cleaning adapters in a container filled with clean
water and trigger a further pump cycle.
6. Wait until the pump cycle is complete.
7. Remove the cleaning adapters and re-fit the filter elements (see Figure 5 Installing the
filter elements on page 6 ).
8. Replace the FILTRATION PROBE sc in the tank; during this process pay attention to
the installation instructions for the fastening system used.