Hach-Lange HQD - BOD LDO Probe LBOD - Manual (Page 9)

DOC272.53.80025 9
7. If prompted, enter a name for the new method settings. Additional changes made to
the settings of an existing method are automatically saved with the same method
name.
8. Push EXIT until the meter returns to the measurement mode.
Change calibration options
1. Make sure a probe is connected to the meter.
2. Push the METER OPTIONS key and select (Probe Model) Settings.
3. Select Modify Current Settings.
4. Select Calibration Options.
5. Update the settings. Refer to Table 3 .
6. If prompted, enter a name for the new method settings. Additional changes made to
the settings of an existing method are automatically saved with the same method
name.
7. Push EXIT until the meter returns to the measurement mode.
Table 3 Calibration options settings
Settings Options Description
Calibration
User — 100%
User — 100% with 0
User — mg/L
User — mg/L with 0 Resolution
Water-saturated air (100%) calibration
Calibration Reminder
Reminder Repeat On 8 h, 12 h, 1 d, 2 d, 5 d, 7 d
Expires
Immediately, Reminder + 30 min, Reminder +
1 h, Reminder + 2 h, Continue Reading