Hydrotech PURA QCUF Quick Change Ultrafiltration Drinking Water System - Manual (Page 17)

15
 4
Step 5 – Start-Up
1. Check system to verify all components are correctly installed
2. Open inlet valve and tank valve.
3. Check system thoroughly for leaks. If any are found, shut off both inlet and tank valves and correct the issue.
4. Open faucet to flush carbon fines & sanitization solution. After allowing the system to run for 20 minutes turn
off the faucet
5. System is ready to use
WarNiNg! Do not drink water produced by the system until the start-up procedure has been
followed completely!
4. Attach locking clips to each white
elbow fitting. Clips should slide in
behind collet on the fittings.