beautypg.com

Facts to remember when planning your installation – Hydrotech 2510 Valve Chemical Free Iron Filter Operation Manual User Manual

Page 5

background image

5

FACTS TO REMEMBER WHEN PLANNING YOUR INSTALLATION

1. All installation procedures must conform to local and state plumbing codes.

2. All water must pass through the hydro-charger, pressure tank and the filter, or refer to the special instructions for a

split-stream installation (System may malfunction if this instruction is ignored.)

3. If lawn sprinkling, a swimming pool, geothermal heating/cooling or water for other devices/activities are to be treated

by the filter, a larger model filter must be selected to accommodate the higher flow rate demands of these items. The
pumping rate of the well pump must be sufficient to accommodate these items plus the backwashing requirement of
the filter. Consult your dealer for alternative instructions if the pumping rate is insufficient.

4. Remember that the filter inlet is attached to the pipe that supplies water (i.e., runs to the pump) and the outlet is the

line that runs toward the water heater.

5. Before commencing the installation it is advisable to study the existing piping system and to determine the size, num-

ber and type of fittings required. Typical system schematics shown in these instructions (Figs. 1, 2 or 3) will be of
assistance. NOTE: If the plumbing system is used as the ground leg of the electric supply, continuity should be main-
tained by installing ground straps around any non conductive plastic piping used in installation.

Section 3: Installation

PROPER INSTALLATION SEQUENCE OF WATER CONDITIONING EQUIPMENT IS VERY
IMPORTANT. REFER TO THE DIAGRAM FOLLOWING FOR YOUR PARTICULAR WATER
SUPPLY.

FIG 1: STANDARD
INSTALLATION

RAW WELL
WATER

RAW
WELL
WATER

RAW WELL
WATER

METER

HYDRO-CHARGER

HYDRO-

CHARGER

TO 110V
OUTLET

TO 110V
OUTLET

SOLENOID

VALVE

SOLENOID

VALVE

(45-60 PSI)

PRESSURE

SWITCH

HYDRO-CHARGER

PRESSURE

SWITCH

SECONDARY
PRESSURE SWITCH

PRIMARY
PRESSURE SWITCH

PRESSURE

TANK

PRESSURE

TANK

SECONDARY

PRESSURE

TANK

PRIMARY

PRESSURE

TANK

TO PUMP

CONTROLLER

TO PUMP

CONTROLLER

RAW WATER

TO OUTDOORS

RAW WATER

TO OUTDOORS

AIR VOLUME CONTROL

(FOR AIR TO WATER

TANKS ONLY)

AIR VOLUME

CONTROL (FOR

AIR TO WATER

TANKS ONLY)

AIR VOLUME CON-
TROL (FOR AIR TO

WATER TANKS ONLY)

MacCLEAN

FILTER

MacCLEAN

FILTER

MacCLEAN

FILTER

SOFTENER

SOFTENER

SOFTENER

IRON FREE WATER

IRON FREE WATER

IRON FREE WATER

IRON FREE
SOFT WATER

IRON
FREE
SOFT
WATER

IRON FREE
SOFT
WATER

AIR RELEASE
VALVE

AIR RELEASE
VALVE

AIR RELEASE
VALVE

FIG 2: SPLIT-STREAM
INSTALLATION

FIG 3:
PUBLIC
WATER
SUPPLY
INSTALLATION

(20-40 PSI)