Hellwig Sway Bar 7700 User Manual
Page 3
ATTENTION INSTALLER: PLEASE MAKE SURE CUSTOMER RECEIVES THIS INSTRUCTION SHEET,
ALL IMPORTANT NOTE CARDS, WARNING CARDS AND THE WARRANTY
FORM
9. With the bar properly aligned, verify that all vehicle components have proper amount of
clearance, and that brake lines, wires, cables, and other components will not be pinched
or crushed when u-bolts are tightened. Torque U-bolts to 35 ft-lb.
10.Bounce the vehicle checking for clearance on all under carriage components – emer-
gency brake cables, exhaust, shocks, differential, etc. Test drive the vehicle and recheck
all clearances and the installation alignment. Adjust as needed. Recheck your installa-
tion after one week of driving and periodically on a regular basis.
11.The sway bar arms have three mounting holes. Mounting the sway bar on the outer hole
is the nominal position. For firmer settings, use the inner holes. We recommend start-
ing with the outer mounting hole as in photo ( 2 ) until you are accustomed to the vehi-
cles new handling characteristics. Select the mounting point that best fits your driving
style
559-734-7451 800-367-5480 FAX 559-734-7460
7700 (R-7700)
06/12/2008