beautypg.com

Hellwig Sway Bar 7698 User Manual

Installation instructions, Rear stabilizer bar 7698

background image

7698 (R-7698)

10/12/2007

TORQUE TABLE

Bolt Size 3/8”— 35 ft lbs * Bolt Size 7/16”— 45 ft lbs* Bolt Size 1/2”—75 ft lbs *Bolt Size 9/16”— 90 ft lbs

SAFETY

: BEFORE BEGINNING INSTALLATION BE SURE TO SET THE PARKING BRAKE

AND CHOCK THE WHEELS.

NOTE:

TO EASE INSTALLATION AND PROPERLY ADJUST THE BAR, THE WEIGHT OF THE

VEHICLE MUST BE ON THE SUSPENSION AS IF DRIVING DOWN THE ROAD. DO NOT RAISE

THE VEHICLE BY THE FRAME.

NOTE:

THIS UNIT IS DESIGNED TO MOUNT TO THE BOTTOM OF THE AXLE TUBES WITH

THE ARMS OF THE BAR TOWARD THE REAR OF THE VEHICLE.

1. Lubricate the D shaped bushings and place them on the straight areas of the bar on each side of

the center hump.

2. Hold bar up to the axle and locate the position on the axle tubes to mount the u-bolts.

Be sure to

put the U-Bolts Under Any Brake Lines, Wires or Hoses on the Axle to Avoid Any Possible

Damage. The threads of the U-Bolts will point down.

3. Install saddles on axle so that they sit squarely on the axle. Place the spacer plates on top of the

saddles. Place the U-Plates over the D shaped bushings on the bar and attach the bar to the U-
Bolts and saddle brackets with the flat washers and nuts provided.

LEAVE LOOSE AT THIS

TIME to allow for adjustment later.

4. For additional bar clearance remove the driver side lower shock bolt, turn it around and reinstall

from the outboard side of the lower shock bracket.

INSTALLATION INSTRUCTIONS

Rear Stabilizer Bar 7698

2007.5+ GM 2500HD-3500HD 2WD-4WD

6.0 Gas Applications Only

Thank you for purchasing a quality Hellwig Product.

559-734-7451 800-367-5480 FAX 559-734-7460