Hellwig Sway Bar 7689 User Manual
Page 2

1.
2006 and newer vehicles may re-use the factory end links if desired as the Hellwig sway bar is a direct replacement for the factory sway
bar on these vehicles. See photo (4). If the end links on your vehicle look like photo (4) the factory end links can be re-used if they are in
good condition.
2.
Install the D-shaped poly bushings on the new sway bar in as close a possible location as the factory sway bar. See photo one ( 1 ).
3.
Position the sway bar up on the vehicles frame, using the U-plate brackets and the factory mounting bolts that were removed in step (1).
Leave loose at this time to allow for adjustment later. Lift the arms of the sway bar over the installed end links and finish the installa-
tion as in photo. See photos one ( 1 ) and four( 4).
4.
With the sway bar properly aligned and the end links straight up and down as possible. Torque the U-plate mounting bolts on the frame
and end link bolts to factory specifications.
5.
Test drive your vehicle and recheck your installation. Re-adjust and torque as necessary. Recheck your installation on a regular basis
thereafter.
4
559-734-7451 800-367-5480 FAX 559-734-7460
Special Instructions for re-use of factory end links on 2006 and newer models
.
7689 ( R-7689)
07/12/2007