beautypg.com

Hellwig Sway Bar 7665 User Manual

Page 2

background image

TORQUE TABLE

BOLT SIZE: 3/8” = 20-30 ft. lbs. – 7/16” = 35-45 ft. lbs. – ½” = 50-70 ft. lbs. – 9/16” = 70-90 ft. lbs

SAFETY:

BEFORE STARTING YOUR INSTALLATION, BE SURE TO SET PARKING BRAKE AND CHOCK TIRES.

NOTE:

TO EASE INSTALLATION AND TO PROPERLY ADJUST THE BAR, THE WEIGHT OF THE VEHICLE MUST BE

ON THE SUSPENSION, AS IF DRIVING DOWN THE ROAD.

DO NOT RAISE VEHICLE BY FRAME.

NOTE:

THIS KIT INCLUDES LOCK NUTS WHICH REQUIRE TIGHTENING WITH A WRENCH AFTER BEING STARTED

BY HAND.

NOTE:

THIS ANTI-SWAY BAR MOUNTS ON THE REAR OF THE AXLE WITH THE ARMS POINTING TOWARDS THE

REAR OF THE VEHICLE.

1. Locate the predrilled mounting on the frame rails. Just behind the rear axle assembly. Install the

frame brackets using the that are provided in this kit.

Leave loose at this time to allow for adjust-

ment later. SEE PHOTO TWO (2).

2. Install the U-bolts on the rear axle with the legs towards the rear of the vehicle. Be sure that the

brake lines are outside of the U-bolt legs and will not be damaged when tightening the U-bolts.

3. Install the D-shaped poly bushings on the sway bar as close as possible to match the U-bolts that

are mounted on the axle. SEE PHOTOS ONE (1) AND THREE (3).

4. Raise the sway bar up to the axle. Position the U-plates over the D-bushings. Using the mounting

hardware provided tighten enough to support the sway bar on the axle.

Leave loose at this time to

allow for adjustment later.

5. Assemble the end link assemblies. SEE DIAGRAM. Install the tube ends of the end links to the

frame brackets that were installed in STEP ONE (1).

Note it may be necessary to lightly grease the

poly bushings and steel sleeves to ease installation.

6. Raise the sway bar arms up to the end link assemblies. Finish the installation of the sway bar arms

to the end links. SEE DIAGRAM.

Tighten until the bushings start to bulge slightly. Over tight-

ening will cause damage to the bushings.

7. With the sway bar centered on the axle and the end links are straight up and down as possible

torque all the mounting hardware to their specified rate. ( The sway bar can be rotated on the axle
and the end links adjusted by the frame hardware ).

8. Check your installation check for clearance on undercarriage components; wires, exhaust, brake

and fuel lines.

9.

After one week of driving recheck your installation readjust if necessary. Recheck your installation
on a monthly regular basis thereafter.

ATTENTION INSTALLER:

BE SURE THAT THE CUSTOMER RECEIVES THIS INSTRUCTION SHEET,

ALL IMORTANT NOTE CARDS AND THE WARRANTY FORM

7665 ( R-7665 )

09/24/04

559-734-7451 800-367-5480 FAX 559-734-7460