Hellwig Sway Bar 7619 - Manual

INSTALLATION INSTRUCTIONS
Rear Stabilizer Bar
S-10, S-15 Pickups
Thank you for purchasing a quality Hellwig Product.
PLEASE READ THIS INSTRUCTION SHEET COMPLETELY BEFORE STARTING YOUR INSTALLATION
TORQUE TABLE
BOLT SIZE: 3/8” = 20-30 ft. lbs. – 7/16” = 35-45 ft. lbs. – ½” = 50-70 ft. lbs. – 9/16” = 70-90 ft. lbs.
SAFETY: BEFORE STARTING YOUR INSTALLATION, BE SURE TO SET PARKING BRAKE AND CHOCK TIRES.
NOTE: TO EASE INSTALLATION AND TO PROPERLY ADJUST BAR, THE WEIGHT OF THE VEHICLE MUST BE
ON THE SUSPENSION, AS IF DRIVING DOWN THE ROAD. DO NOT RAISE VEHICLE BY FRAME.
1. As shown in picture 2, locate the square U-bolts over the top of the frame rail directly behind the shock brackets. Be sure to
put U-bolts under any brake lines, wires, cables, or hoses to avoid possible damage. Install hanger brackets with slotted
holes toward rear of vehicle. There are left (driver’s side) and right (passenger side) versions of the hanger brackets so care
must be taken to install the brackets on the correct side of the vehicle. When oriented correctly, the brackets will install as
shown in picture 2.
2. Install flat washers and nuts on the U-bolts. LEAVE LOOSE AT THIS TIME.
2
7619 (R-376) 08/07/03
1 2
559-734-7451 800-367-5480 FAX 559-734-7460