Hellwig Sway Bar 7608 User Manual

Page 2

TORQUE TABLE

BOLT SIZE: 3/8” = 20-30 ft. lbs. – 7/16” = 35-45 ft. lbs. – ½” = 50-70 ft. lbs. – 9/16” = 70-90 ft. lbs.

SAFETY:

BEFORE STARTING YOUR INSTALLATION, BE SURE TO SET PARKING BRAKE AND CHOCK TIRES.

NOTE:

TO EASE INSTALLATION AND TO PROPERLY ADJUST BAR, THE WEIGHT OF THE VEHICLE MUST BE ON

THE SUSPENSION, AS IF DRIVING DOWN THE ROAD.

DO NOT RAISE VEHICLE BY FRAME.

NOTE:

THIS UNIT IS DESIGNED TO REPLACE THE FACTORY INSTALLED REAR ANTI-SWAY BAR OR AS AN

ADDITION IF ONE IS NOT FACTOTY INSTALLED . ON VEHICLES WITHOUT A FACTORY REAR BAR IT MAY BE

NECESSARY TO DRILL THE FRAME BRACKET MOUNT HOLES IN THE BOTTOM OF THE FRAME. THIS BAR

MOUNTS TO THE BOTTOM OF THE AXLE TUBES WITH THE ARMS OF THE BAR TOWARDS THE FRONT OF

THE VEHICLE.

NOTE:

THIS KIT INCLUDES LOCK NUTS WHICH REQUIRE TIGHTENING WITH A WRENCH AFTER BEING

STARTED BY HAND.

Without Factory RSB Brackets

Vehicles w/o factory RSB brackets.
Enlarge this hole using 1/2” Drill bit.
This hole will be used to attach the
clevis to the frame using the supplied
1/2” bolt, locknut, and washer.

7608 ( R7608)

02/06/06

559-734-7451 800-367-5480 FAX 559-734-7460