beautypg.com

Hellwig Sway Bar 7463 User Manual

Page 2

background image

559-734-7451 800-367-5480 FAX 559-734-7460

( R-162 ) 11/29/2012

1. Place U-bolt and mounting plate on spring behind rear axle, place offset holes in plate toward axle,

Photo 1. Secure tightly.

2. Lubricate the inside and place four poly bushings on sway bar, place bar on the rear spring behind axle,

see illustration.

3. Install plates, bolts and nuts, as shown in illustrations. Do not tighten
4. Align sway bar arms so arms are directly centered over vehicle springs.
5. Tighten all brackets, U-bolts and nuts securely.
6. Bounce the vehicle and check for clearance on all undercarriage components. Be sure all nuts and bolts

are securely fastened and double nuts used where necessary or provided.

7. Recheck your installation, look for clearance between gas lines, exhaust pipes, brake lines, wiring, etc.

After one week of driving check your installation and periodically thereafter.

ATTENTION INSTALLER: BE SURE THE CUSTOMER RECEIVES THIS INSTRUCTION

SHEET, ALL IMPORTANT NOTE CARDS, WARNING CARDS AND THE WARRANTY FORM.

SAFETY: BEFORE STARTING YOUR INSTALLATION, BE SURE TO SET PARKING BRAKE AND CHOCK TIRES.

NOTE: TO EASE INSTALLATION AND TO PROPERLY ADJUST THE BAR, THE WEIGHT OF THE VEHICLE MUST BE

ON THE SUSPENSION, AS IF DRIVING DOWN THE ROAD. DO NOT RAISE VEHICLE BY THE FRAME.

NOTE: THIS KIT MAY INCLUDE LOCK NUTS WHICH REQUIRES TIGHTENING WITH A WRENCH AFTER BEING

STARTED BY HAND.

TORQUE TABLE

BOLT SIZE: 3/8” = 20-30 ft. lbs. – 7/16” = 35-45 ft. lbs. – 1/2” = 50-70 ft. lbs. – 9/16” = 70-90 ft. lbs.-5/8”=120 ft. lbs.