Driver’s side, Passenger side – Hellwig Sway Bar 7721 User Manual
Page 3
12. Center sway bar on axle and tighten axle U-bolts to 60 ft-lb. Double nut axle u-bolts after torquing to spec.
13. Bounce the vehicle checking for clearance on all under carriage components: fuel tank, shocks, exhaust,
differential, brake and fuel lines, etc. Test drive the vehicle and recheck all clearances and the installation
alignment. Adjust as needed. Re-check your installation after one week of driving and periodically on a regular
basis.
14. The sway bar has three end link mounting holes. The end link MUST be mounted on the outer hole for
initial use. For a firmer setting, use the inner holes. You must use the outer mounting hole until you are
accustomed to the vehicles new handling characteristics. After driving vehicle, a firmer setting may be
selected if desired. It is recommended that the outer hole be used for street driving.
ATTENTION INSTALLER: PLEASE MAKE SURE CUSTOMER RECEIVES THIS INSTRUCTION
SHEET,ALL IMPORTANT NOTE CARDS, WARNING CARDS AND THE
WARRANTY FORM
Driver’s Side
559-734-7451 800-367-5480 FAX 559-734-7460
Passenger Side
7721 (R-7721) 04/24/2012