Hellwig Sway Bar 7275 - Manual

INSTALLATION INSTRUCTIONS
FRONT STABILIZER BAR
2011+ F-450/550 Front Sway Bar
Thank you for purchasing a quality Hellwig Product.
PLEASE READ THIS INSTRUCTION SHEET COMPLETELY BEFORE STARTING YOUR INSTALLATION
7275( R-7275 ) 04/26/11
1. Remove the factory installed sway bar and all the mounting hardware. Do not discard the end link assemblies
and the U-plate mounting bolts as they will be used for reinstallation of the new front sway bar.
2. Install the D-shaped poly bushings on the sway bar in the same location as the factory sway bar. Position the
sway bar up on the vehicles frame using the U-plates provided. Fasten with the mounting bolts that were re-
moved in step (1).
Leave loose at this time to allow for adjustment later. .
3. With the sway bar properly aligned and the end links are aligned properly, torque all the mounting hardware to
the factory specifications.
4. Test drive your vehicle and recheck your installation re-torque if necessary. Recheck your installation on a
regular basis thereafter.
ATTENTION INSTALLER: BE SURE THAT THE CUSTOMER RECEIVES THIS INSTRUCTION
SHEET, ALL IMORTANT NOTE CARDS AND THE WARRANTY FORM
TORQUE TABLE
BOLT SIZE: 3/8” = 20-30 ft. lbs. – 7/16” = 35-45 ft. lbs. – ½” = 50-70 ft. lbs. – 9/16” = 70-90 ft. lbs.
SAFETY: BEFORE STARTING YOUR INSTALLATION, BE SURE TO SET PARKING BRAKE AND CHOCK TIRES.
NOTE: TO EASE INSTALLATION AND TO PROPERLY ADJUST BAR, THE WEIGHT OF THE VEHICLE MUST BE ON THE SUSPEN-
SION, AS IF DRIVING DOWN THE ROAD. DO NOT RAISE VEHICLE BY FRAME.
NOTE: THIS ANTI SWAY BAR IS DESIGNED TO REPLACE THE FACTORY MOUNTED SWAY BAR USING THE FACTORY END
LINKS AND MOUNTING HARDWARE FOR THE U-PLATES AND THE FACTORY END LINKS.
559-734-7451 800-367-5480 FAX 559-734-7460