Hellwig Sway Bar 7266 User Manual
Page 2

9.
Thread jam nut and hex nut on to threads of end link far enough to mount flat washers and bushings to the end of sway bar as shown in
photo three (3). Attach sway bar to end link using locknuts provided in kit.
LEAVE LOOSE AT THIS TIME to allow for adjustment
later.
10.
With sway bar loosely mounted, work bar back and forth in D-shaped poly bushings to center bar.
11.
Tighten frame bracket U-bolts to 50 ft-lb..
12.
Tighten end link clevis bolts to specs in torque table.
13.
Tighten end link nuts until poly bushings start to bulge slightly.
DO NOT OVERTIGHTEN. Tighten jam nut against upper nut on end
link to lock into place.
14.
Tighten axle U-bolts to torque spec in torque table. Place second nut on U-bolt and tighten against primary nut to lock in place.
15.
Recheck your installation, looking for clearance on any undercarriage components, such as gas lines, exhaust pipes, brake lines, wiring,
differential cover, etc.
16.
Drive vehicle for a few miles, then recheck for position and tightness, readjust and retorque as needed. Then recheck periodically
thereafter.
ATTENTION INSTALLER: PLEASE MAKE SURE CUSTOMER RECEIVES THIS INSTRUCTION SHEET,
ALL IMPORTANT NOTE CARDS, WARNING CARDS AND THE WARRANTY
559-734-7451 800-367-5480 FAX 559-734-7460
Hex Nut
Passenger Side
Driver Side
Jam Nut
Lock Nut
3a
3b
7266 (R-7266)
11/19/2010