Hellwig Sway Bar 5802 - Manual (Page 3)

7. Lubricate d-bushings and place on end of sway bar as shown in photo (6). Attach d-
bushings to spring plate with supplied u-plate and factory fasteners.
8. Tighten bolts in spring plate to factory specification.
9. If holes were drilled in subframe to mount hanger, tighten through-bolt to 25 ft-lb.
10. Tighten end link hanger bolts to 25 ft-lb or until bushings bulge slightly.
11. Bounce vehicle a couple of times and check installation for clearance to fuel and brake
lines and other components. After one week of driving recheck your installation and
fastener torque. Recheck on a regular basis thereafter.
ATTENTION INSTALLER: BE SURE THAT THE CUSTOMER RECEIVES THIS INSTRUC
TION SHEET, ALL IMORTANT NOTE CARDS AND THE
WARRANTY FORM
559-734-7451 800-367-5480 FAX 559-734-7460
5 6
5802 ( R-5802 ) 02/15/07