Hellwig Air 6106 - Manual (Page 5)

559-734-7451 800-367-5480 FAX 559-734-7460
7. Insert limiter tab over bump stop tongue
as shown.
8. Reinstall axle bracket and attach air
spring to limiter tab and axle bracket using
3/8” x 1” bolt as shown. Tighten bolt to
20-25 ft-lb. Insert legs of U-bolt through
holes in bracket. It is preferred to use the
upper holes, but if U-bolt cannot be in-
stalled in upper holes, use the lower holes
as shown. Attach U-bolt using 3/8”
flanged lock nuts and tighten until bracket
flexes slightly.
8
6106 ( R-6106) 11/22/06
7
9
9. Check your installation to ensure that
all fasteners are tight and that the assembly
and all fasteners clear brake and fuel lines,
emergency brake cables, fuel tanks, wiring
harnesses, etc. Make sure that heat shields
are positioned for maximum protection of
air spring.
Air spring bolt
Limiter Tab