Alto-Shaam AR-7E/VH - Manual (Page 25)

C A R E A N D C L E A N I N G
A R - 7 E V H E l e c t r i c R o t i s s e r i e w i t h Ve n t l e s s H o o d O p e r a t i o n & C a r e M a n u a l • 2 3
S E R V I C E
D A N G E R
DISCONNECT UNIT FROM
POWER SOURCE BEFORE
CLEANING OR SERVICING.
D A N G E R
ELECTRICAL CONNECTIONS MUST
BE MADE BY A QUALIFIED SERVICE
TECHNICIAN IN ACCORDANCE WITH
APPLICABLE ELECTRICAL CODES.
Check for physical damage and loose screws. Correct any problems before they begin to interfere with the
operation of the oven.
C H E C K O V E R A L L C O N D I T I O N O F T H E R O T I S S E R I E O N C E A M O N T H
C A U T I O N
TO PROTECT STAINLESS STEEL
SURFACES, COMPLETELY AVOID
THE USE OF ABRASIVE CLEANING
COMPOUNDS, CHLORIDE BASED
CLEANERS, OR CLEANERS
CONTAINING QUATERNARY SALTS.
NEVER USE HYDROCHLORIC ACID
(MURIATIC ACID) ON STAINLESS
STEEL. NEVER USE WIRE
BRUSHES, METAL SCOURING
PADS OR SCRAPERS.
N
O
SCRAPER
S
N
O
W
IRE
BRUS
H
E
S
N
O
ST
EEL PA
D
S
D A N G E R
AT NO TIME SHOULD THE INTERIOR
OR EXTERIOR BE STEAM CLEANED,
HOSED DOWN, OR FLOODED WITH
WATER OR LIQUID SOLUTION OF
ANY KIND. DO NOT USE WATER JET
TO CLEAN.
SEVERE DAMAGE OR
ELECTRICAL HAZARD
COULD RESULT.
WARRANTY BECOMES VOID IF
APPLIANCE IS FLOODED
D A N G E R
L O C K - O U T O R P O S T
B R E A K E R PA N E L U N T I L
S E R V I C E W O R K H A S
B E E N C O M P L E T E D .
C A U T I O N
THIS SECTION IS PROVIDED FOR THE ASSISTANCE
OF QUALIFIED SERVICE TECHNICIANS ONLY AND
IS NOT INTENDED FOR USE BY UNTRAINED OR
UNAUTHORIZED SERVICE PERSONNEL.