Global Specialties 1310 - Manual (Page 7)

MONITORS : 3 digit LED display. Voltage or current
display selectd by V/A switch. A or B
supply display by A / B switch. Display
accuracy ±0.5%, ±1 digit. Resolution
of 1mA when displaying current,0.1V
when displaying voltage LED indicates
overload on 5V supply
SHORT CIRCUIT : All supplies current limited ( external
PROTECTION short circuit will not damage power
supplies ).
LINE CORD : 3 Wire with American Plug.
DIMENSION ( H x W x D ) : 70mm x 265mm x 322mm.
WEIGHT : 2.585 Kgs.
3
The board can now be removed by lifting the PC board, front panel,
and rear panel straight upward from the case as a unit. If desired, the
connectors may be unplugged from the PC board to facilitate service;
note the position of each connector and mark them to ensure proper
reassembly.
6.4 CASE REASSEMBLY :
The reassemble the case, refer to figure 7 ( Case Assembly ) and
proceed as follows:
1. Remove all connections to the binding posts and unplug the 1310
from the AC supply. Ensure that both upper and lower case halves are
clean and free of debris.
2. If the PC board has been removed from the upper case half, replace it
as follows :
a) If the front and rear panels have been disconnected from the
PC board: slide the front panel and rear panels into the
appropriate grooves ( the front of the case is the beveled side )
in the upper half of the case, while allowing the main PC board
to drop into the case
b) If the front and rear panels have been disconnected from the
PC board: set the PC board into the upper case half, observing
orientation ( i.e., while facing the front [ beveled side ] of the
upper case half, the heat sinkds on the PC board should be to
the right ). Install the front and rear panels into their appropriate
grooves, noting that they should be "upside-down", and plug
the panel connectors into the main PC board.
c) Loosely install the four hex stand offs that hold the main PC
board to the upper case half.
d) Install the self-tapping screw in the center of the PC board,
being careful not to over tighten.
e) Now tighten the four hex stand offs holding the main PC board.
3. Gently slide the lower case half straight down into position atop the
upper case half, making sure that the beveled sides face the front and
that the front and rear panels are fitting properly in the case panel
grooves.
4. Position the flip-up leg and the foot assemblies. The flip-up leg
assembly should be to the front, and the leg should fold rearward.
5. Replace the Philips-head screw in each foot assembly, taking care
not to over-tighten.
6. Replace the stick-on rubber feet.
7. Return the 1310 to the upright position.
18