Global Specialties PRO-1000 - Manual - Manual (Page 11)

11
2. INSTALLATION
2-1. Initial Inspection
The PRO-1000 was carefully inspected both mechanically and electrically before shipment and should
be free of any physical damage. Please inspect the instrument for any physical damage that may
have occurred in transit.
2-2. Connecting AC Power
This instrument may be used with either 115V AC, or 230V AC (50-60 Hz) input voltages. Please
ensure that the power socket includes a protective earth contact (PE-contact).
CAUTION
AC POWER OF THIS INSTRUMENT IS FACTORY-SET TO 115V. BEFORE POWER-UP, CHECK
AND MAKE SURE THE VOLTAGE OF THE POWER SOURCE IS SAME THE INSTRUMENT
’S
FACTORY PRESET.
FOR 230V AC INPUT VOLTAGE REQUIREMENTS, ADJUST THE VOLTAGE SELECTOR SWITCH
ON THE REAR OF THE METER.
2-3. Cooling and Ventilation
No special cooling or ventilation is required for proper operation however the instrument should be
operated within its intended ambient temperature specifications for optimum use.
2-4. Position
The PRO-1000 is a bench-type instrument with rubber feet and handle-type tilt stand. The viewing
angle can be adjusted by rotating angle of carrying handle.
2-5. Warm-Up
Allow 30 minutes for the unit to warm up in order to provide the most accurate and stable readings.