Alamo 800 - Manual (Page 11)

SAFETY
800 01/11 Safety Section 1-7
© 2011 Alamo Group Inc.
SAFETY
Operate the Tractor and/or Implement controls only while properly seated in the Tractor seat
with the seat belt securely fastened around you. Inadvertent movement of the Tractor or
Implement may cause serious injury or death.
(SG-29)
Be particularly careful when transporting the Implement with the Tractor. Turn curves or go
up hills only at a low speed and using a gradual steering angle. Rear mounted implements
move the center of gravity to the rear and remove weight from the front wheels. Make
certain, by adding front ballast, that at least 20% of the tractor’s weight is on the front wheels
to prevent rearing up, loss of steering control or Tractor tip-over. Slow down on rough or
uneven surfaces to prevent loss of steering control which could result in property damage
or possible injury. Do not transport unless 3-Point lift lever is fully raised and in the latched
transport position. Dropping implement in transport can cause serious damage to the
tractor and/or Implement and possibly cause the operator or others to be injured or killed.
(S3PT-02)
Relieve hydraulic pressure prior to doing any maintenance or repair work
on the Implement. Place the Implement on the ground or securely
blocked up, disengage the PTO, and turn off the tractor engine. Push
and pull the Remote Cylinder lever in and out several times prior to
starting any maintenance or repair work.
(S3PT-09)
This Implement may be wider than the Tractor. Be careful when operating or transporting
this equipment to prevent the Implement from running into or striking sign posts, guard rails,
concrete abutments or other solid objects. Such an impact could cause the Implement and
Tractor to pivot violently resulting in loss of steering control, serious injury, or even death.
Never allow the Implement to contact obstacles.
(S3PT-12)
There are obvious and hidden potential hazards in operating Rear Blades and Box Scrapers
as in all power-driven equipment. REMEMBER! This machine is often operated in rough
terrain conditions that include gullies, holes, slopes, hidden obstructions and the like.
Serious injury or even death may occur unless care is taken to assure the personal safety of
the operator and bystanders in the area.
(SBL-1)
NEVER PARK BLADE ON THE BACK OF THE MOLDBOARD. Inadvertent falling could
cause serious injury or even death. ALWAYS LOWER HITCH onto stand or onto secure
blocks.
(SBL-2)
Keep fingers clear of adjusting holes. A sudden movement could cause injury or even
amputate fingers. KEEP CHILDREN AWAY WHEN MAKING ADJUSTMENTS.
(SBL-3)
Never leave blade unattended in the lifted position. Accidental operation of lifting lever or a
hydraulic failure may cause sudden drop of unit with subsequent injury or death by crushing.
Lower Stand and pin in place, or put a secure support under the A-Frame. Lower Blade
carefully to the ground. Do not put hands or feet under lifted components.
(SBL-4)