Avaya 201-type - Manual (Page 3)

1
Overview
The 201-type Module Recorder Interface is an optional device that, when installed with the Avaya 2420 Digital
Telephone, allows you to record telephone conversations.
In addition, this module allows you to use the two headset jacks on the 20-type stand rather than a single headset
jack directly connected to the 2420 telephone.
NOTE: Disconnect the 2420 telephone from the wall jack and remove power before removing and/or installing
the 201-type module. Refer to the 20-Type Stand, 200-Type Module Analog (U.S.) Adjunct Interface, and
201-Type Module Recorder Interface Installation and Safety Instructions (555-233-132) for more information.
Requirements
The 201-type module requires the installation of the 20-type stand. Refer to the 20-Type Stand, 200-Type Module
Analog (U.S.) Adjunct Interface, and 201-Type Module Recorder Interface Installation and Safety Instructions
(555-233-132) for more information.
Switch Settings
Two sets of switches are provided on the 201-type module, allowing you to:
•
enable/disable the “beep tone” that alerts callers when you are recording the call in progress
•
specify whether the single headset jack on the 2420 telephone or the dual headset jacks on the 20-type stand
are active
NOTE: The headset jacks on the 20-type stand and the one on the 2420 telephone cannot be active
simultaneously.
Refer to the 20-Type Stand, 200-Type Module Analog (U.S.) Adjunct Interface, and 201-Type Module Recorder
Interface Installation and Safety Instructions (555-233-132) for more information.
Headsets Supported
The headset adapter cord used with the 2420 telephone is not compatible with the headset jacks on the 20-type
stand. When the 20-type stand is installed, a separate adapter cord (Quick Disconnect to Black RJ, part ID
407721034) is used with the headset jacks on the 20-type stand. Unlike the headset jack on the 2420 telephone,
the headset jacks on the 20-type stand are intended for use without an auxiliary amplifier base unit (M12LUCM) or
amplifier adapter cord (HIC-1). (The Quick Disconnect to Black RJ adapter cord is not compatible with the
headset jack on the 2420 telephone.) The following headsets are supported:
•
Starset top H31
•
Mirage top H41
•
Mirage top H41N
•
Supra Monaural top H51
•
Supra Monaural NC top H51N
•
Supra Binaural top H61
•
Supra Binaural NC top H61N
•
Encore Monaural Voice Tube H91
•
Encore Monaural NC top H91N
•
Encore Binaural Voice Tube H101
•
Encore Binaural NC top H101N