ELRO CR1 WLAN Repeater USERS MANUAL - Manual (Page 43)

802.11n WiFi Repeater User’s Manual
43
9
LAN Interface
This chapter is to configure the parameters for local area
network which connects to the LAN port of your Access Point.
Here you may change the setting for IP address, subnet mask,
DHCP, etc...
Note
You should only change the addressing details if your ISP asks
you to, or if you are familiar with network configuration. In most
cases, you will not need to make any changes to this
configuration.
LAN Interface Setup
To check the configuration of LAN Interface:
1. From the left-hand Network Settings -> LAN Interface
menu. The following page is displayed: