Testing your setup, Default device settings – ELRO CR1 WLAN Repeater USERS MANUAL User Manual
Page 36

802.11n WiFi Repeater
User’s Manual
36
1. Enter your user name and password. The first time you log
into the program, use these defaults:
User Name:
admin
Password:
admin
Note
You can change the password at any time or you can configure your
device so that you do not need to enter a password. See Password.
2. Click on OK. You are now ready to configure your device.
This is the first page displayed each time you log in to the Web
pages.
Note
If you receive an error message or the Welcome page is not
displayed, see Troubleshooting Suggestions.
Testing your Setup
Once you have connected your hardware and configured your
PCs, any computer on your WLAN should be able to use the
DSL /Cable connection to access the Internet.
To test the connection, turn on the device, wait for 30 seconds
and then verify that the LEDs are illuminated as follows:
Table 1. LED Indicators
Label
Color
Function
POWER
green
On: device is powered on
Off: device is powered off
WLAN
green
On: WLAN link established and active
Blink: Valid Wireless packet being transferred
WPS
green
Off: WPS link
isn’t established and active
Blink: Valid WPS packet being transferred
If the LEDs illuminate as expected, test your Internet connection
from a LAN computer. To do this, open your web browser, and
type the URL of any external website (such as
solid as the device connects to the front AP.
Default device settings
In addition to handling the xDSL / Cable modem connection to
your ISP, the device can provide a variety of services to your