ELRO FA420DVR 4-ch digital recorder + 500 gb hard disc USERS MANUAL - Manual (Page 36)

Page 36
Figure 4.5 Set Area
【
Arm/Disarm Schedule
】
DVR triggers motion detection alarm signal only during the time periods
set up as in Figure 4.6. Recording can be scheduled weekly or in a general calendar. Each day is
divided into four time sections. The time range will take effect only if the checkbox
■
before the time
range is ticked.
Figure 4.6 Time Range Setup
【
Time Interval
】
Within the scheduled time interval, if there are several occurrences, the detection
only triggers alarm in sequence;
【
Alarm Output
】
When motion occurs, the setting will activate corresponding external devices
connected to the alarm output port;
【
Delay
】
Indicate the extended time for which the alarm will continue after the alarm ends, ranging
from 10~300 seconds
；
【
Recording Channel
】
Select the desired recording channel (Can be ticked). When alarm is
triggered, the system will activate the recording signal on that channel
;
Note: To perform corresponding video recording, it requires the settings in
【
Record Settings
】
to activate test recording in the defined time periods
【
Auto Sequence
】
Highlighted
■ ■ ■ ■
indicates it is selected. When alarm signal is present, the