Biamp ELD-1 User Manual
Page 7
7
ELD-1 INSTALLATION
Installation
The ELD-1 may be mounted in a rack or on a wall using four screws at the end of the flanges or two screws in the keyholes on the rear.
Please install the unit away from heat sources, such as vents and radiators, and in rooms with adequate ventilation. Do not exceed the
maximum operating temperature of 32-113 degrees F (45°C).
An ELD-1 should be connected at the end of every speaker line that is to be monitored. The diagram below shows the appropriate connection
to the speaker wire and the network. In EN54-16 compliant systems the ELD-1 must be connected to a compliant Ethernet switch that is
backed by an uninterruptible power supply (UPS).
Vocia Amplifier with ELD-1 Wiring Topology
VO-4e Emergency Output device with ELD-1 Wiring Topology