DE DIETRICH NEO 2.1 - Manual (Page 10)

4 Installation
4.1 Regulations governing installation
CAUTION
4
The installation must comply in all matters to the
standards and rules which govern the work and
interventions in individual and collective homes, and
other constructions.
4
The installation and maintenance of the appliance
must be carried out by a qualified professional in
compliance with the statutory texts of the codes of
conduct in force.
4
Before installation, make sure that the framework is
solid and strong enough to comply with the static
requirements.
4
Solar installations must be earthed to protect them
against lightning.
4
Protection of the environment: Place a container of
sufficient volume under the drain pipe and the valve
discharge pipe.
4
The roof-integral installation set is designed specifically as a
mounting system for the NEO 2.1 / SUN 211 flat solar panels and
may only be used in accordance with their building regulations
approval.
4
The installation set is designed for rooves with standard roof
tiles (Flat tile,mechanical tiles). If using particularly large tiles
(canal tiles, Roman tiles), consult a technical adviser.
4
The roof mounting kit is used to install solar collectors on roofs
with a minimum gradient of 20° protected by plastic (protective
tarpaulin).
4
The water drainage channels on the membrane should run into
the eaves (roof gutter).
4
The installation should therefore not be flushed or filled when the
collectors are hot (in strong sunshine).
4
The solar system must at all times be filled with heat transporting
fluid:Tyfocor L or LS.
M001788-A
M001707-A
4. Installation NEO 2.1 / SUN 211
9 30/11/2011 - 300021356-001-F