EBARA EFQT3 - Manual (Page 4)

EBARA Fluid Handling 4
INTRODUCTION
This Installation, Operation, and Maintenance manual is designed to help you get the best
performance and longest life from your EBARA pump.
This pump is a EFQT Series, semi-open impeller, self-priming centrifugal model with a suction check
valve.
The pump is designed for handling mild industrial corrosives, mud or slurries containing large
entrained solids. The basic material of construction is gray iron, with ductile iron impeller and steel
wearing parts.
If there are any questions regarding the pump or its applications which are not covered in this manual or in
other literature accompanying this unit, please contact your EBARA distributor, or write:
EBARA Fluid Handling
1651 Cedar Line Drive
Rock Hill, SC 29730
For information or technical assistance on the power source, contact the power source
manufacture’s local dealer or representative.
The following are used to alert maintenance personnel to procedures which require special attention,
to those which could damage equipment, and to those which could be dangerous to personnel:
Immediate hazards which WILL result in
severe personal injury or death. These
instructions describe the procedure
required and the injury which will result
from failure to follow procedure.
CAUTION! DANGER!
Hazards or unsafe practices which
COULD result in minor personal injury or
product or property damage. These
instructions describe the requirements
and the possible damage which could
result from failure to follow the
procedure.
NOTE
Instructions to aid in installation,
operation, and maintenance or which
clarify a procedure.