DRIVEN UCT4060 Chain Cutting & Press-Fit Tool - Manual (Page 2)

Important! RK recommends using rivet type connecting links whenever possible for the most
secure connection.
Installation/Press-fitting of Sideplate:
1. Review the drawings for reference. Route chain over and around counter shaft sprocket (Figure 1A).
2. If applicable, put 1 O-ring over each connecting link pin. Slide the pins through the two ends of the chain from the back to connect the chain
near the bottom of the rear sprocket (Figure 1B).
3. If applicable, put the other two O-rings over each pin and spread the excess grease over all the O-rings.
4. Insert the correct plate holder for the chain (see Plate Holder Selection below) into the large pressure bolt hole and position the connecting
link side plate in the plate holder (Figure 2A).
5. Place the tool/plate holder/sideplate assembly under the connecting link and align the pins with the side plate holes (Figure 2B).
6. Turn the pressure bolt by hand making sure to keep the pins and side plate holes aligned until snug (Figure 2B).
7. Use a 17mm socket and ratchet wrench to tighten the bolt. The side plate should press-fit firmly but without difficulty.
8. Tighten bolt to correct depth allowed by plate holder channel (do not over-torque). Loosen bolt and remove tool.
Installing The Clip
1. Using thin-nose pliers, snap clip into pin grooves with closed end of clip facing rotational direction of chain (Figure 3A).
2. Warning!!! Make sure the clip is properly tension-seated in the groove of the pins. If the clip is loose, walk the side plate up the
pins with pliers until it is snug against the clip. NEVER REUSE A CONNECTING LINK.
1A
Clip Type
2A
Rivet Type
Ready to press
Plate completely
pressed
3B
RK Pin Hole Riveting:
First, follow procedures 1-8 above.
1. Remove plate holder and insert flare pin FP5060 into the large pressure bolt of the tool and insert tail piece TP4060 into hole in tool wall
opposite the pressure bolt.
2. Place the tool under the connecting link. Align the flare pin with the hole in the end of the pin. Make sure the other end of the link pin is seated
in the tail piece (Figure 3B). Tighten the bolt by hand so that the flare pin is snug against the link pin hole.
3. Use a 17mm socket and ratchet wrench to tighten the bolt until the pin hole is flared out sufficiently to keep the side plate from coming off.
Repeat this procedure for the second pin.
4. Warning!!! Tighten the bolt only until firm resistance is felt, then loosen the bolt and inspect the pin for complete, even flaring. Do
not over-tighten the bolt – you may bend or damage the link pins or bind the link entirely. A pronounced, even flare will securely
connect the chain links together.
Plate Holder Selection:
PH4060C – To press-fit Clip sideplates for 520/525/530/532/630/632 O-ring.
PH5060R – To press-fit Rivet sideplates for 520/525/530/532/630/632 O-ring.
1B