DRIVEN UCT4060 Chain Cutting & Press-Fit Tool - Manual

UCT4060 Chain Cutting & Press-Fit Tool Instructions
To break a chain:
1. Thread the large pressure bolt PB4060 into the tool body TB4060.
2. Insert the chain cutting tail piece TP4050 into the opposite side of the tool body.
3. Position the chain to be cut between the hole in the end of the large pressure bolt and the hole in the tail piece
(Figure 1A).
4. Using a 17mm wrench, snug up the large pressure bolt so that the chain pin is held firmly in place.
5. Slide the cutting pin holder CP4050H onto the cutting pin CP4050.
6. Thread the cutting pin holder into the small pressure bolt PB4050 (Figure 1B).
7. Thread the small pressure bolt into the large pressure bolt (Figure 1C).
8. Using a 14mm wrench, turn the small pressure bolt until the chain pin is pushed completely through the side plates.
CAUTION: The first few turns will be very hard as the quad stake riveted edges on the chain pin are pushed through
the side plate. If it seems exceptionally hard, check the alignment of the chain pin with the hole in the end of the
large pressure bolt.
NOTE: If you are cutting a new chain to length, be sure to remove the chain pin that will leave you with an inner
side plate as the end of the chain. A connecting link can only be installed onto inner side plates.
CP4050
Cutting Pin
PB4050
Small Pressure Bolt
CP4050H
Cutting Pin Holder
FP5060
Rivet Flare Pin
TP4050
Tail Piece for Chain Cutting
PH4060C
Clip Link Plate Holder
PH5060R
Rivet Link Plate Holder
PB4060
Large Pressure Bolt
TP4060
Tail Piece for Press Fitting
BH4060
Black Handle
TB4060
Tool Body
TOOL COMPONENTS
TP4050
WARNING! DO NOT USE TOOL TO CUT 630 AND 632 TYPE CHAIN!
1A 1B 1C
PB4060
PB4050
CP4050
CP4050H
DO NOT CUT
MASTER LINK !