A o m - 7 6 9 4 – ASA Electronics AOM-7694 User Manual
Page 2
IMPORTANT! - Please Read This Manual Before Installing!
Congratulations on your purchase of a Voyager AOM-7694 LCD Observation Monitor.
With proper installation and use, your AOM-7694 LCD is designed to provide you with years
of trouble-free operation. Please read this manual thoroughly prior to beginning.
All Voyager Observation products are strictly intended to be installed as a supplemental aid
to standard rear-view mirror systems that may already exist in your vehicle. Voyager
Observation products are not intended for use as substitutes for rear-view mirror devices or for
any other standard motor vehicle equipment required by law.
While Voyager observation products contribute to improving the vehicle operator's field
of view, these products are no substitute for proper defensive driving techniques and
observance of traffic laws and motor vehicle safety regulations.
Warnings!
Installation Location
It is unlawful in most jurisdictions for a person to drive a motor vehicle equipped with a
television viewer or screen located at any point forward of the back of the driver's seat or
in any location that is visible, directly or indirectly, to the driver while operating
the vehicle. The AOM-7694 product is designed to be used primarily as a rear observation
device in conjunction with a closed circuit camera. In any installation where the AOM-7694
is used to display television broadcasts or recorded video, the installation location
must adhere to local laws and regulations.
Tampering
Moisture
Your Voyager AOM-7694 was not designed to be water-resistant. While it will withstand short
periods of exposure to moisture, this product does contain sensitive electronic
components and exposure to moisture should be limited by the user/installer. This product is
not designed for constant exposure to moisture or immersion.
This unit should NEVER be cleaned with a power washer or used where direct power washer
spray may be encountered.
A O M - 7 6 9 4
A O M - 7 6 9 4
2
RED POWER WIRE MUST BE CONNECTED TO ACCESSORY TO AVOID CURRENT
DRAW IN THE KEY OFF POSITION.
OBJECTS VIEWED IN MONITOR ARE CLOSER THAN THEY APPEAR.
Depth of view