AmpliVox SW3230 - Manual (Page 5)

AmpliVox SS / SW3230 RTA ASSEMBLY INSTRUCTIONS
5
GETTING STARTED
TOOLS NEEDED: Philips Screw Driver or Power Screwdriver, Rubber Mallet
• Unpack all panels from shipping box. Locate accessory box and open.
CASTER PANEL
• Locate Panel (4). Panel (4) has pilot holes on one side.
Other side is smooth. Place smooth side down on a flat
smooth surface.
• Locate the four casters (O). Two casters are locking.
These will be installed on the side where there is no
cutout.
The other two non locking casters are installed on the
side with the cutout. Use four of the (J) screws for
each caster.
• Locate four "L" brackets (R). Locate the four
remaining pilot holes on the panel. Screw one bracket
facing to the outside of panel into each pilot hole,
using one (J) screw per bracket.
• Set panel aside.
CAM LOCK AND DOWEL PIN INSTALLATION
• Locate Panels (1) (4) (5) and (11), items (E) and (P).
Lay all the panels on a flat surface with the side that
has all the cutouts facing up.
• Take one item (P) Cam Lock, and press into
each cutout with your fingers or softly tap in with
rubber
mallet.
• Repeat on all panels.
• On the edges of all four panels you will see
holes for the dowel pins, item (E). Insert a
dowel pin into each hole.
• Set all panels aside.