Ariens Sno-Thro 939003-ST520E - Manual (Page 7)

GB - 9
PACKAGE CONTENTS
ASSEMBLY
Tools Required:
• Pliers
• Open-End Wrenches: 3/8, 7/16, 1/2,
9/16 in. and/or Adjustable Wrench
• Tire Gauge
Unfold Handlebar (Figure 4)
1. Remove the lower and loosen the upper
hardware on the handlebar assembly.
2. Rotate the handlebars into operating position.
3. Install and tighten the hardware on the handlebar
assembly.
Install Discharge Chute
(Figure 5)
1. Grease underside of discharge chute ring (if not
already greased).
2. Remove mounting hardware from the bottom of
the chute pedestal.
3. Install discharge chute over opening in the auger
housing and secure pedestal to auger housing
with hardware removed in step 2.
ASSEMBLY
WARNING: AVOID INJURY. Read and
understand the entire Safety section before
proceeding.
WARNING: Dropping or tipping over boxed
unit could result in personal injury or damage
to unit.
Figure 3
1. Discharge Chute
2. Chute Crank
3. Sno-Thro Unit 4. Literature Pack with
Extra Shear Bolts
3
2
1
4
Figure 4
1. Lower
Handlebar
2. Hardware
3. Upper
Handlebar
OS7035
2
3
1
1
Figure 5
1. Mounting Hardware
2. Discharge Chute 3. Discharge Chute Ring
4. Chute Pedestal
1
1
3 2
OS7050
OS7055
4