Com-Power CGO-5100B User Manual
Application, Features, Description
Application
Most EMC regulatory agencies require EMI labs to
perform regular calibration of test equipment and
test sites used for EMI emission measurements.
Most EMC labs calibrate their sites and test
equipment annually to ensure this requirement is
met. However, it is prudent to check the sites and
test equipment more frequently to ensure the data
taken on the site is accurate and consistent. The
normal calibration methods are not practical for a
quick check. The solution is to use a Comb Generator
as reference signal source.
The test engineer can keep a regular log of Comb
Generators radiated readings. This data can be used
to detect potential problems with site or equipment
by monitoring any significant changes. Using this
method, potentially costly measurements error can
be avoided. Without regular monitoring a broken
antenna, a bad cable, blown preamplifier and poor
RF connections may go undetected. The Comb
Generator can be also used compare several sites to
determine the impact of the site on the test data.
Other applications for the comb Generator include
testing shielding effectiveness of an enclosure and
materials.
Features
Reference Signal Source for EMI Test Sites
100 MHz Frequency Steps
Usable Frequency Range up to 18 GHz
Battery Powered
Three Year Warranty
CGO-5100B
Comb Generators
Description
The CGO-5100B Comb Generator is a radiated
reference signal source with a 100 MHz frequency
step size. Unlike a signal generator the Comb
Generator radiates all the harmonics at the same
time without any need of tuning. The CGO-5100B has
a frequency stability of 5 PPM and radiate signals
up to 18 GHz.
This Comb Generators have a built in antenna which
is located on top of the circular chassis. The chassis
shape helps the Comb Generator radiate the signal
more uniformly in all directions in the horizontal
plane. It can be turned on its side for vertical plane
measurements, but is generally not recommended
because the influence of the ground plane on the
radiation pattern.
The CGO-5100B is powered by rechargeable internal
NimH batteries. Using a battery eliminates the need
for external cabling that may interfere with the
radiated signals. When fully charged, the battery
allows continuous use of the Comb Generator for
up to 18 hours. The Comb Generator and the charger
are shipped with a custom wooden storage box.
Com-Power Corporation
19121 El Toro Road, Silverado, California 92676
(949) 459 - 9600
Rev. D04.14