CHIEF PACHFK2 - Manual (Page 6)

PACHFK2 Installation Instructions
6
2. Orient header and footer brackets (A) within the cut-out
drywall area. (See Figure 3)
Figure 3
3. Raise and lower brackets (A) until brackets rest against
center stud. (See Figure 4)
NOTE: Front flange on both upper and lower bracket should be
slid behind drywall. (See Figure 5)
Figure 4
Figure 5
4. Make sure upper and lower brackets are level and there is
a minimum of 20.375" between them at bracket centers and
at both ends of brackets.
5. Secure upper and lower brackets to center studs using four
08 x 1-1/2" Phillips flat head wood screws (B) at center
studs. (See Figure 6)
6. Secure upper and lower brackets to side studs using
sixteen M7 x 40mm connector screws (C) and M4 Allen
head bit (D). (See Figure 6)
Figure 6
(A) x 2
2
(A) x 2
Center Stud
Center Stud
3
Front
flange
of bracket
Drywall
(B) x 4
(C) x 16 6
5