CHIEF FCA650_651 - Manual (Page 6)

FCA650/651 Installation Instructions
6
Assembly And Installation
NOTE: The following procedure assumes the Fusion Cart/
Stand has already been completely assembled.
IMPORTANT ! : The FCA650/651 has been designed
specifically for Chief’s Fusion™ Series Carts and Stands.
DO NOT attempt to install this CPU holder onto any other
cart or stand!
1. Remove back cover from cart/stand. (See Figure 1)
2. Remove column inner cover from cart/stand. (See Figure 1)
3. Remove side cover from cart/stand by sliding it up the side
channel on the side where the CPU holder will be installed.
(See Figure 1)
Figure 1
4. Partially install 1/4-20 x 3/8" set screw (F) into accessory
bracket (C). (See Figure 2)
5. Slide accessory bracket (C) with set screw into side channel
where CPU holder will be installed. (See Figure 2)
Figure 2
6. Slide accessory bracket up or down in side channel until
desired mounting height is reached. (See Figure 3)
7. Tighten set screw (F) to lock bracket in position. (See Figure
3)
8. Use two 1/4-20 x 3/8" button head cap screws (E) to secure
adapter bracket (B) to accessory bracket (C). (See Figure 3)
Figure 3
(display not shown for clarity)
2
2
3
1
1
side covers
column inner
cover
back cover
(display not shown for clarity)
(C)
(F) 4
5
(B)
(E) x 2 8
6
7