CHIEF KTA1001 - Manual (Page 5)

Installation Instructions KTA1001
5
INSTALLATION
Mount and Site Preparation
Mount Preparation
To prepare existing mount arrays for
connection:
1. Remove end lock from array rail ends to be joined using
5/32" hex key. (See Figure 1)
NOTE: Leave square nut in array rail after removing end lock.
Figure 1
To install the KTA1001:
1. Insert two square nuts (D) into each rail end. (See Figure 2)
2. Slide rails together until rail ends meet. (See Figure 2)
Figure 2
3. Place connecting bracket (A) against rails aligning holes in
connector bracket with square nuts installed during step 1.
(See Figure 3)
NOTE: The two center square nuts must align with holes in rail
ends.
4. Secure connector bracket outer mounting holes to array
rails using two 1/4-20 x 1/2" button head cap screws (B)
making sure each screw threads into a square nut (D). (See
Figure 3)
5. Secure connector bracket inner mounting holes to array
rails using two 1/4-20 x 3/4" button head cap screw (C)
making sure each screw threads into a square nut (D) and
through hole in array rail. (See Figure 3)
CAUTION: Center connector mounting screws must go
through square nut and hole in array rail to maintain mount
integrity.
Figure 3
Array rail connection is now complete. Refer to Installation
Instructions provided with mount or other accessory for
additional installation instructions if required.
End Lock
Square Nut
Array Rail
1
(D) x 2
(D) x 2
Array Rail
1
1
2
Array Rail
(A)
(C) x 2
Array Rail
5
4 (B) x 2