CHIEF MAC720 - Manual (Page 4)

MAC720 Installation Instructions
4
ASSEMBLY AND INSTALLATION
WARNING: EXCEEDING MAXIMUM WEIGHT CAPACITY
MAY LEAD TO SERIOUS PERSONAL INJURY OR
DAMAGE TO EQUIPMENT! It is the installer’s responsibility
to ensure the total amount of weight placed on the cart/stand
does not exceed 125 lbs (56.70 kg) for the MFC, 125 lbs
(56.70 kg) for the MF1, and 250 lbs (113.40 kg) for the MF2
[125 lbs (56.70 kg) per faceplate].
Installing Display(s) to Cart/Stand
1. Install display(s) to cart or stand following the installation
instructions included with the cart/stand.
Assembly for Single Display
1. Attach faceplate (A) to bracket (B) using two 3/8-16 x 1"
roundhead carriage bolts (H), two spacers (E), and two
3/8-16 Nylock lock nuts (G). (See Figure 1)
Figure 1
2. Secure faceplate with bracket to clamp bracket (C) using
four 5/16-18 x 3/4" buttonhead cap screws (D).
(See Figure 2)
NOTE: The faceplate assembly must be attached to the clamp
bracket below the knob on the lower part of the cart/
stand post.
Figure 2
Assembly for Dual Display
WARNING: TIPPING HAZARD! Place MAC720 only on
FRONT of MFC and MF1. MAC720 may be placed on both
FRONT and BACK of MF2.
1. Attach first faceplate (A) to bracket (B) using two 3/8-16 x 1"
roundhead carriage bolts (H), two spacers (E), and two
3/8-16 Nylock lock nuts (G). (See Figure 1)
2. Attach second faceplate (A) to bracket (B) using two
3/8-16 x 1" roundhead carriage bolts (H), two spacers (E)
and two 3/8-16and two 3/8-16 Nylock lock nuts (G). (See
Figure 3)
Figure 3
1
(A)
(B)
(H) x 2
(E) x 2
(G) x 2
(C)
2 (D) x 4
(MF1 shown)
MAC720 must be
installed BELOW
the knob located
on the post back.
(A)
(E) x 2
(B)
(G) x 2
2 (H) x 2