CHIEF PAC720 - Manual (Page 4)

PAC720 Installation Instructions
4
ASSEMBLY AND INSTALLATION
WARNING: EXCEEDING MAXIMUM WEIGHT CAPACITY
MAY LEAD TO SERIOUS PERSONAL INJURY OR
DAMAGE TO EQUIPMENT! It is the installer’s responsibility
to ensure the total amount of weight placed on the cart/stand
does not exceed 200 lbs (90.72 kg) for the PFC, 200 lbs
(90.72 kg) for the PF1, 400 lbs (181.44 kg) for the PF2
[200 lbs (90.72 kg) per faceplate].
Installing Display(s) to Cart/Stand
1. Install display(s) to cart or stand following the installation
instructions included with the cart/stand.
Assembling Faceplate to Bracket
1. Attach faceplate (A) to bracket (B) using two 3/8-16 Nylock
lock nuts (E). (See Figure 1)
Figure 1
2. Secure faceplate with bracket around post to clamp bracket
(C) using four 5/16-18 x 3/4" buttonhead cap screws (D).
NOTE: The faceplate assembly must be attached to the clamp
bracket below the knob on the lower part of the cart/
stand post.
Figure 2
Assembly for Dual Display
WARNING: TIPPING HAZARD! Place PAC720 only on
FRONT of PFC and PF1. PAC720 may be placed on both
FRONT and BACK of PF2.
1. Attach first faceplate (A) to bracket (B) using two 3/8-16
Nylock lock nuts (E). (See Figure 1)
2. Attach second faceplate (A) to bracket (B) using two 3/8-16
Nylock lock nuts (E). (See Figure 3)
Figure 3
3. Secure faceplate assemblies with bracket to clamp brackets
(C) onto cart/stand post using four 5/16-18 x 3/4"
buttonhead cap screws (D) on EACH assembly. (See
Figure 4)
(A)
(B)
(E) x 2
1
(C)
2 (D) x 4
(PFC shown)
PAC720 must be
installed BELOW
the knob located
on the post back.
(A)
(B)
(E) x 2
2