CHIEF KSA1020 - Manual (Page 11)

Installation Instructions KSA-1020
11
Installing Mount to Desk
WARNING: Failure to provide adequate structural strength
for this component can result in serious personal injury or
damage to equipment! It is the installer’s responsibility to
make sure the desk to which this component is attached can
support five times the combined weight of all equipment.
Reinforce the structure as required before installing the
component.
NOTE: The following instructions are for mounting with full
360° swivel capability for easy cord access. If this
capability is not desired, connect mounting bracket
using two screws as demonstrated in the Installing to
Wood Studs section.
1. Determine location for mount keeping in mind CPU size and
safety requirements.
2. Using bracket and swivel bearing (D) as a template, mark
and drill one 17/64" diameter pilot hole through underside of
desk at desired mounting location. Ensure entire mount will
clear the outer edge of desk. (See Figure 17)
Figure 17
3. Install 3/8 x 1-1/4" hex head lag screw (F) through bearing
(D) and mounting bracket into hole drilled in Step 2. (See
Figure 17)
4. Ensure bracket flag is in the open position. (See Figure 16)
5. Insert four mounting buttons into four mounting holes on the
bracket. (See Figure 18)
Figure 18
6. Slide buttons into locked position within holes.
7. Move flag to closed position in order to fully secure mount
to bracket. (See Figure 16)
(D)
(F)
2
3
Desk
Mounting bracket
Latching flag
(desk not shown)
5